E02 on the Valley ICON 10 / ICON 1
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
What it means
PCB HARDWARE ISSUE.
One code that covers eighteen numbered problems on the circuit board: the cut cable relay input, the 5 volt regulator, the main supply input, the battery charging voltage, the switched 12 volt output, the thermally fused 12 volt and 5 volt sensor and daughter card outputs, and the 3.3 volt regulator. The issue number shown with it is what identifies the fault, so write that number down for your dealer. E02 alone is not enough to go on. It shuts the machine down.
This one stops the machine.
Call a technician for this one, rather than opening the panel.
E02 on other panels
This page is for the Valley ICON 10 / ICON 1. The same code on another panel can mean something else:
- Valley ICON 5 / ICON XPCB HARDWARE ISSUE
- Valley TouchPro · different meaningEEPROM: checksum failed at power up
- Valley Pro / Pro2 · different meaningEEPROM checksum failed at power up
- Valley Select2 · different meaningEEPROM checksum failed at power up
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.