Zimmatic 712C error codes
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
33 listed for this panel. Tap one for the full explanation. These only apply to this panel. On a different panel the same code, light or message can mean something else.
All 33 error codes
- 200STOPPED
- 201FORWARD
- 202REVERSE
- 301Power Delay: waiting for voltage to come above the low threshold before starting the motors
- 302Restart Delay: delaying a pump restart after a power cycle or an operator stopping and starting, to prevent water hammer
- 303Pressure-up Delay: waiting for pressure to reach the threshold
- 305Roto-phase Delay: giving a roto-phase converter time to bring all three phases up before engaging motors
- 308Barrier Hold: stopped and watering in place at a barrier for the programmed hold time, before reversing or stopping
- 400Low Pressure Warning
- 401High Flow Warning
- 402Low Flow Warning
- 403In Soft Barrier: running inside an area it was told to stay out of
- 406Cable error: the span cable failed a continuity test
- 407Low Pressure Warning (Aux)
- 500Soft Barrier: reached a programmed soft barrier positionStops the machine
- 501Auto-Shutdown: reached a physical hard barrierStops the machine
- 502Service Stop: stopped at the programmed service stop positionStops the machine
- 503Load Control: shut down because the load control schedule says it must be off nowStops the machine
- 600Stall Timer: the machine stopped changing position and the overwater timer expiredStops the machine
- 602GPS Lost: GPS was lost and the dead reckoning timer ran outStops the machine
- 603Low VoltageStops the machine
- 604High VoltageStops the machine
- 605Load Control: shut down because the load control schedule says it must be off nowStops the machine
- 606GPS Direction Error: position is moving opposite to the commanded direction, which points at direction lines wired wrongStops the machine
- 607GPS Fence: the receiver is outside the geo-fence band around the pivot lengthStops the machine
- 608Low PressureStops the machine
- 610Pressure Time: failed to build pressure within the pressure-up limitStops the machine
- 611Low Aux PressureStops the machine
- 613Low TemperatureStops the machine
- 618High RainStops the machine
- 620Plan Missing: a plan was selected to run but does not existStops the machine
- 700Alignment: the alignment circuit is openStops the machine
- 701Direction: both forward and reverse lines were commanded at onceStops the machine
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.