Panel Goes to Off by Itself on the Zimmatic BOSS
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
What it means
The panel drops to Off by itself, often while a chemical or accessory output is running.
This looks like a panel fault or a random shutdown. When it happens while the panel is running a chemical injection pump or another accessory, the usual cause is electrical noise coming back from the relay or contactor the panel switches for it. Note whether that option was running each time the panel dropped to Off and pass that along. Fitting a part to quiet the noise is a job for a technician.
Call a technician for this one, rather than opening the panel.
This is what it means on the Zimmatic BOSS. On a different panel the same light or message can mean something else. Wrong panel? Pick another Zimmatic panel.
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.