Auto-stop at Barrier on the Zimmatic Vision
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
What it means
The machine stopped at a hard barrier, a physical barricade.
The machine reached a hard barrier, a real barricade in the field, and stopped as it was set to. This differs from a soft barrier stop, where nothing is actually touched. If it shows this nowhere near a barricade, the panel is seeing power on the forward and reverse lines at the same time. That points at a wiring problem out on the machine, not a panel setting. If none or only a few towers were moving, that points at a bad neutral connection on the pivot. A short between the forward and reverse lines on the machine can also do it.
This one stops the machine.
Reading the display and looking the machine over with every door and cover closed is fine. Anything past that means power shut off and locked out at the main disconnect first, and electrical checks belong to a dealer, an electrician, or someone qualified to be in the panel.
This is what it means on the Zimmatic Vision. On a different panel the same light or message can mean something else. Wrong panel? Pick another Zimmatic panel.
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.