T-L Precision Point Touch screen colors, safeties and statuses
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
22 listed for this panel. Tap one for the full explanation. These only apply to this panel. On a different panel the same code, light or message can mean something else.
All 22 screen colors, safeties and statuses
- Green Pivot GraphicRunning normally
- Red Pivot GraphicStopped because a safety has tripped
- Yellow Pivot GraphicA delay or timer is running, not a fault
- Gray Pivot GraphicA feature or span is not fitted to this machine
- Safety Disclaimer ScreenAppears at every power-up and needs a touch to continue
- Actual Speed Reads ZeroNo speed signal is reaching the panel
- ET Sensor SafetyThe system isn't getting a speed signal from the end towerStops the machine
- Overwater SafetyThe end tower is stuckStops the machine
- Wrong Direction SafetyThe system moved opposite to the direction it was set to runStops the machine
- Auto Stop ShutdownThe auto-stop angle was reached or the end tower switch trippedStops the machine
- GPS Comm LostThe panel cannot detect the GPS antennaStops the machine
- Encoder Comm LostThe panel has lost communication with the encoderStops the machine
- GPS ErrorThe GPS is seeing fewer than 3 satellitesStops the machine
- Position Stop ShutdownThe programmed stop angle was reachedStops the machine
- Soft Start RampSpeed is ramping up gradually after a stop
- Start DelayThe start is being held on purpose
- Auto RestartThe system restarts itself after certain stops
- Automatic Speed ControlThe system is fine-tuning its own speed
- Angle-Based Auto StopAn angle setting can override the end tower reversing switch
- SPD- / SPD+ LightsLight briefly during a speed adjustmentCall a technician
- RX LightFlashing about once a second is normal communicationCall a technician
- SPD Pulses LightShows whether speed-sensor pulses are reaching the boardCall a technician
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.