E06 on the Valley ICON 5 / ICON X

An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.

What it means

PRESSURE TOO LOW AFTER PRESSURE DELAY.

Stops the machine

Leads to a Low Pressure fault. Causes: the startup pressure delay is too short, the pump or pressure transducer or pressure switch has failed, or the low pressure limit is set too close to actual operating pressure.

Before you touch anything

This one stops the machine.

Reading the display and looking the machine over with every door and cover closed is fine. Anything past that means power shut off and locked out at the main disconnect first, and electrical checks belong to a dealer, an electrician, or someone qualified to be in the panel.

E06 on other panels

This page is for the Valley ICON 5 / ICON X. The same code on another panel can mean something else:

Safety

Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.

FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.