E06 on the Valley Pro / Pro2
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
What it means on the Pro2
Pump safety: pressure still too low after the pressure delay expired.
Either the machine is really not making pressure, or the pressure delay is set too short for this system to come up. It shuts the machine down, and the machine stays down until someone restarts it, so find out which one it is before restarting.
Reading the display and looking the machine over with every door and cover closed is fine. Anything past that means power shut off and locked out at the main disconnect first, and electrical checks belong to a dealer, an electrician, or someone qualified to be in the panel.
What it means on the Pro
Pump safety: pressure too low after the pressure delay expired.
The panel shows a pressure fault after a 30 second delay. The usual causes, most common first: the pressure delay is set too short for this machine to build pressure, the low pressure limit is set too high, or the pump really is not making pressure. A failed pressure sensor is also possible. You or your dealer can check the delay and limit settings and the pump side.
This one stops the machine.
E06 on other panels
This page is for the Valley Pro / Pro2. The same code on another panel can mean something else:
- Valley ICON 5 / ICON X · different meaningPRESSURE TOO LOW AFTER PRESSURE DELAY
- Valley ICON 10 / ICON 1 · different meaningPRESSURE TOO LOW AFTER PRESSURE DELAY
- Valley TouchPro · different meaningPump safety: pressure too low after the pressure delay
- Valley Select2 · different meaningPump safety, pressure too low after the pressure delay
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.