Valley TouchPro error codes
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
25 listed for this panel. Tap one for the full explanation. These only apply to this panel. On a different panel the same code, light or message can mean something else.
All 25 error codes
- E01BBRAM: checksum failed at power up
- E02EEPROM: checksum failed at power up
- E03Unit resets: logged when the software resets
- E04Power drop: power dropped below the low voltage limit
- E05System safety: possible tower misalignment, drive unit may be stuck
- E06Pump safety: pressure too low after the pressure delay
- E07Pressure sensor out of range high
- E08Pressure sensor out of range low
- E09Pressure sensor reads high with the pump off
- E10Pressure sensor: mechanical switch could be stuck
- E11Resolver: angle jumping around. Lube the J pipe
- E12Resolver (position sensor) out of range high
- E13Keypad: a key may be stuck
- E14Forward/reverse sense: possible short
- E15Underwater error: the machine may be moving too fast
- E18GPS communications error
- E19GPS signal loss: check for a clear path above the antenna
- E20DGPS signal loss: check for a clear path above the antenna
- E21LOW FLOW
- E22HIGH PRESSURE
- E23PLC communications error (GPS V2 only)
- E24RESYNC VALVE DUTY CYCLE DUE TO PRESSURE
- E25GPS coordinates out of range: check distance to GPS, or for crosstalk
- E26LOW TIRE PRESSURE
- E27TPMS COMMUNICATIONS ERROR
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.