713 on the Zimmatic FieldNET Pivot Control
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
What it means
Two Second Timer Shutdown: the system failed to attempt a restart after the two second delay timer activated.
A 700-series code is a full shutdown and goes to the dealer. It usually shows at start up. The panel did not see voltage on the safety circuit within two seconds, which points to a problem on the safety circuit. On a machine run off a generator that does this at start up, the usual fix is a roto-phase delay, the start-up delay that waits for the power to come up to operating level.
Call a technician for this one, rather than opening the panel.
This is what 713 means on the Zimmatic FieldNET Pivot Control. On a different panel it can mean something else. Wrong panel? Pick another Zimmatic panel.
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.