Zimmatic FieldNET Pivot Control error codes
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
27 listed for this panel. Tap one for the full explanation. These only apply to this panel. On a different panel the same code, light or message can mean something else.
All 27 error codes
- 200System Stopped: the system has stopped normally
- 201Running Forward: operating in the forward direction
- 202Running Reverse: operating in the reverse direction
- 300Stall Delay: the stall timer is running
- 301Power Startup Delay: delayed until power is at operating levels
- 302Water Restart Delay: will resume watering once pressure is built
- 303Pressure Pre-delay: waiting for water pressure to come up before it starts
- 304Position Delay: out of position and attempting to correct itself before operating normally again
- 305Pressure Post-delay: pressure is at operating level and the system delays momentarily before irrigating
- 400Low Pressure Warning: nearing the low pressure limit for shutdown
- 401High Flow Warning: nearing the high flow limit for shutdown
- 402Low Flow Warning: nearing the low flow limit for shutdown
- 403Soft Barrier Warning: nearing the programmed Soft Barrier
- 404Position Warning: the machine is drifting off its GPS position
- 405Two Second Timer Warning: the two second timer has started, and if no restart is attempted in that time the system shuts down
- 500Soft Barrier Stop: stopped at the Soft Barrier locationStops the machine
- 501Auto-Stop at barricade: Auto-Stop engaged at the physical barricadeStops the machine
- 502Service Stop: reached and activated the service stopStops the machine
- 600Position Shutdown: the system has gone out of GPS positionStops the machine
- 601Low Pressure Shutdown: low pressure caused shutdownStops the machine
- 602Low Temperature Shutdown: low temperature caused shutdownStops the machine
- 603Service Power Shutdown: a problem with the incoming power shut it downStops the machine
- 604Rainfall Shutdown: the climate sensor collection bucket filled to capacity and shut the system downStops the machine
- 700Safety Shutdown: a safety tripped and shut the system downStops the machineCall a technician
- 701Low Flow Shutdown: flow level too lowStops the machineCall a technician
- 713Two Second Timer Shutdown: the system failed to attempt a restart after the two second delay timer activatedStops the machineCall a technician
- 714Fwd & Rev Stuck on Shutdown: the panel saw voltage on both direction lines for more than 20 seconds, which points at a bad direction microswitch or a bad auto reverse boxStops the machineCall a technician
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.