Low Pressure Shutdown on the Zimmatic Vision
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
What it means
Water pressure dropped below the shutdown set point.
The water pressure fell below the low pressure set point that is programmed into the panel. When good pressure comes back, the panel starts the machine again by itself. That is how the machine can be stopped and started from the pump when the field is too wet to get to it. Treat a machine stopped this way as live whenever the pump could come back on.
This one stops the machine.
This is what it means on the Zimmatic Vision. On a different panel the same light or message can mean something else. Wrong panel? Pick another Zimmatic panel.
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.