Plus sign (+) next to speed percentage on the Reinke RPM Preferred

An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.

What it means

A plus sign means the end tower is moving right now.

A plus sign next to the speed percentage on the main screen means the end tower is moving at this moment. Below 100 percent the end tower runs part of each timer cycle and sits the rest, so the plus sign comes and goes. That is normal.

This is what it means on the Reinke RPM Preferred. On a different panel the same light or message can mean something else. Wrong panel? Pick another Reinke panel.

Safety

Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.

FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.