GPS + SBAS lights, off on the Zimmatic BOSS and Vision GPS position unit
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
What it means
No GPS data reaching the main panel from the GPS unit.
With the machine running for a few minutes, if the GPS light and the SBAS (correction-signal) light next to it are both off, the main panel is not getting any GPS data from the GPS unit out on the machine. That points to a communication or equipment problem rather than a setting. On a stopped machine the GPS unit has no power, so these lights being off then is normal. The lights are on a board inside the main panel, so do not open a live panel to look at them.
Call a technician for this one, rather than opening the panel.
This is what it means on the Zimmatic BOSS and Vision GPS position unit. On a different panel the same light or message can mean something else. Wrong panel? Pick another Zimmatic panel.
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.