Valley Select diagnostic symbols and codes
An independent guide from FixMyPivot, not from the manufacturer. Brand and panel names are here only so you can find your own equipment.
9 listed for this panel. Tap one for the full explanation. These only apply to this panel. On a different panel the same code, light or message can mean something else.
A blank diagnostics area means none of the five symbols is showing. The four E codes do not show there. They flash in the voltage window, back and forth with the voltage reading.
All 9 diagnostic symbols and codes
- Lightning bolt symbolPower failed or voltage dropped too lowCall a technician
- Pressure gauge symbolWater pressure fell below the low pressure setting
- Boxed V symbolMachine was commanded to stop, or the panel has a fault
- Safety symbolThe machine's safety circuit is incompleteCall a technician
- Circular arrow symbolMachine shut down at its programmed stop-in-slot spot
- E20Pressure reading is out of range, too highCall a technician
- E25Analog-to-digital converter faultCall a technician
- E33Relay board is not communicating with the panelCall a technician
- E35Resolver faultCall a technician
Safety
Center pivots run on high voltage and heavy moving machinery. Shut off and lock out power at the main disconnect before you open a panel or touch anything electrical. If you are not sure, stop and call your local pivot dealer or a licensed electrician. These pages tell you what a code means. They do not replace a qualified technician, and the safety instructions that came with your equipment come first.
FixMyPivot is an independent troubleshooting service. It is not affiliated with, authorized by, or sponsored by any equipment manufacturer. All brand, panel and product names are trademarks of their owners and are used here only to identify the equipment a code appears on. This information is general, is provided as is without warranty, and may not match the software version on your panel. Use of these pages is subject to our Terms of Service.